Welcome to Shanghai Clirik Machinery CO.,ltd! If you have any questions please concact us Email:sales@clirik,com Tel:86-21-20236178 86-13917147829

PRODUCTS

Your current location:HOME> Products

Crushing Equipment 首页 > Product > Crushing Equipment

European Version Hammer Crusher

Capacity:
10-100T/H
Feeding size:
≤50mm
Output Size:
≤8mm
Applied material:

metallurgy, mining, chemical, cement, coal, sand-making, coal gangue, construction, refractory materials and ceramic industries.

  • Main Specification
  • Technical Data
  • Features
  • Working principle

European Version Hammer Crusher is engaging in crushing various rocks and stones with comprehensive strength not higher than 320 MPa into coarse powder and small particles, it is widely used in metallurgy, mining, chemical, cement, coal, sand-making, coal gangue, construction, refractory materials and ceramic industries. 

Type

PC400x300

PC600x400

PC800x600

Rotor Diameter /mm

400

600

800

Rotor Width/ mm

300

400

600

Rotor Speed/ r/min

1100

1000

900

Max Feeding Size/mm

<100

<220

<350

Finished particle size /mm

0-10

0-20

0-22

Capacity / t/h

3-8

8-15

15-45

Power /kw

11

18.5-22

45

Hammer Number /pieces

12-16

12-20

20-28

Dimension L*W*H/mm

855*795*860

1150*1095*1230

2360*1490*1415

High capacity and low power consumption;

Uniform particle size with high crushing and crushing ratio;

Simple structure;

Easy operation; 

low investment.

European Version Hammer Crusher mainly consists of frame, rotor, support iron and grate bars. The frame is divided into two parts: upper part and lower part, which are welded by steel plates after being cut. Liners made of high manganese steels within the frame can be replaced after being worn out. The rotors consist of turn plates, pin shafts, and hammers which are grouped regularly in the main shaft. The main unit drives the main shaft through the motor and triangle belts, which, in turn, rotates the rollers. Large materials entering the crusher through the feed inlet are firstly crushed by the high-speed hammers, and then thrown fiercely to the support iron for further crushing. Qualified materials crushed will be screened out and exit from the gap of the grate bars while the unqualified will be left in the crushing cavity to be further hammered and ground until reach the standard size. The size of the final product can be adjusted by changing the grate bars. The gap between the rotors and the grate bars can also be adjusted according to different requirement. To avoid the plugging of the crusher, the proportion of water for the crushing materials is no more than 20%.

CONTACT US

If you have any requirements or questions, please leave a message, we will reply you as soon as possible!

*